6-10W STEREO AUDIO AMPLIFIER WITH IC TDA2005 CIRCUIT SCHEMATIC DIAGRAM
his is a class AB stereo audio power amplifier designed for quality hi-fi applications using a power IC TDA2005. It is easy to construct and has a minimum of external components. The module has output current protection and thermal protection. This is the data book circuit which produces an excellent sound. The supply voltage required for this kit is 8 – 18V DC at 1 to 2 Amps.
Maximum output power will only be obtained with a power supply of at least 2A at 15V DC, and using 2 ohm speakers (or 2 by 4 ohm speakers in parallel). However approximately 4W per channel can be obtained with only a 15V DC, 1A supply into 4 ohm loads.
The power supply should be well filtered to reduce mains hum, the on board capacitors alone are not adequate for this purpose but are necessary to ensure stability. Extra filtering is unnecessary if operating from a battery.
other circuit
-
CIRCUIT POWER AMPLIFIER 2000 WATT SCHEMATIC DIAGRAM This is linear amplifier which need advance knowledge in electronics since the schematic...
-
NiCd – NiMH Battery Charger circuit diagram Note: I is 1/10 of the battery’s charging capacity. For example if battery has a rated capac...
-
CIRCUIT 13.8 VOLT 20 A TRANSFORMERLESS POWER SUPPLY SCHEMATIC DIAGRAM This 13.8 Volt 20 A regulated transformerless power supply. 20A transf...
-
Trainer Mikro Lengkap berbasis SMARTAVR ATmega 8535 ver 4.0 Kit trainer lengkap cocok untuk kampus dan individu, mikrokontroler berbasis ATM...